Basic Ergo Razor Side Wall Planer Instructions

Side wall removal is necessary to allow the edge cutting tools to cut or polish the edges. If you are seeing plastic in your files or stones, it’s time for you to remove the side wall where the top of the side edge meets the side of your boards (see image upper left). The SkiMan Ergo Razor Side Wall Planer works basically the same as variations and it’s cousins branded under several ski and snowboard tuning tool companies.

If disassembled, simply put the post in the hole in the planer body and tighten with the knob or included hex wrench so it looks like this:

You can flip the direction of the blade for pulling on the left or right side. The knob also controls the in and out location of the blade to position it relative to where the edge meets the side wall. The two screws on top are for setting the height. The blade should just skim/plane the side wall in thin slices. Adjust deeper as needed and as you use repetitive strokes. If it skips, it’s cutting too much and you need to back off.

The blade post can accept either a round blade or a rounded square for optimal planing depending on side wall shape. The hex wrench can be used to replace or rotate the blade to a fresher and sharper cutting edge.

After planing you may wish to touch up the planed area with a fine file, sandpaper and/or tex pad.

For more side wall planing and cutting tips, see: Planing and Cutting Back SideWalls.

Updated: 4/7/13 for additional information.

Leave a Reply